Set the network type to Infrastructure. Your wireless adapter should be configured to operate with an access point or residential gateway. This mode of operation is typically enabled by setting network type to Infrastructure. Set the wireless network name. The wireless network name of your gateway is 2WIRE in all capital letters, followed by the last three digits of the gateway serial number located on the bottom of your gateway. For example, if the last three digits of your gateway serial number are , your gateway network name would be 2WIRE Enable wireless security.
Your gateway is pre-configured to take advantage of wireless security. Referring to the instructions provided with your wireless adapter, enable wireless security.
The default wireless security used by the gateway is sometimes referred to as WEP wired equivalent privacy , bit encryption, or bit encryption. When prompted to enter a key code, select the appropriate key code from the table on page 1, enter it into the key code field, and click.
You may be prompted to enter service provider information such as username and password. Enter any required service provider information and click.
The connection process will begin. During this process the. This step could take up to five minutes as the gateway searches for your broadband service. The gateway will now connect to the Internet. This process may take several minutes. Once connected, click the. Your gateway setup is now complete.
You can connect additional computers to your network by following these steps.
0コメント